3DAeroventures Super Chipmunk Build Manual page 24

Step-by-Step Build Guide (cont'd)
Step 3.1 Cut Carbon Fiber Tubes to Length
The Horizontal Stabilizer and the Vertical Stabilizer are each reinforced with a
carbon fiber tube. Cut two 6mm diameter carbon fiber tubes to these lengths
using a cutting disk on a rotary tool:
- 500mm Long for Horizontal Stab
- 220mm Long for Vertical Stab
Set the tubes aside for a later step.
Step 3.2 Glue Vert Stab and Horiz Stab Parts Together
3.2.1 Prior to gluing the Stab parts together, make sure your carbon fiber hinge
rod fits in the hinge hole on each part. If needed, clear out the hinge holes
with a 1.2 to 1.7mm drill bit, depending on what size hinge rod you are using.
3D
Aeroventures
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 2� -