Step-by-Step Build Guide (cont'd)
Step 4.3 Glue the Wing Parts Together
4.3.1 Prior to gluing the wing parts together, make sure your carbon fiber hinge
rod fits in the hinge hole on each part. If needed, clear out the hinge holes
with a 1.2 to 1.7mm drill bit, depending on what size hinge rod you are using.
4.3.2 Glue parts Wingtip R, Wing R5, Wing R4, Wing R3, and Wing R2 together.
The built-in alignment aids and the carbon fiber tube will keep the parts
aligned during assembly.
ATTENTION: One of the 600mm (24") long carbon fiber tubes runs the length
between Wing R2 and Wingtip R. Do not glue Wing R1 in place without this
carbon fiber tube in place.
Wingtip R
Wing R5
3D
Aeroventures
Wing R4
Wing R3
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Wing R2
6mm O.D. x 600mm (24")
Long Carbon Fiber Tube
Glued in place prior to
assembling Wing R1
- 3� -