Advertisement
Step-by-Step Build Guide (cont'd)
Step 8. Final Radio and Motor Installation
Tools and Materials Needed:
- Screwdriver for servo mounting screws and servo covers
- Allen wrench for M3 screws
- Needle nose pliers
- Velcro strips with adhesive backing
Hardware/Electronics Needed (links to recommended hardware on pg 5):
- 2mm (or 2-56) diam. steel wire with threaded ends for servo control rods
- 30" long for elevator (x2) and rudder
- 12" long for ailerons (x2)
- M2 or #2 Thread Forming or Tapping Screws for mounting servo covers (x8)
- M4 x 0.7mm Thread x 16mm Long Screws for Motor Mount (x4)
- M4 x 0.7mm Thread Lock Nut for Motor Mount (x4)
- M3 x 0.5mm Thread x 25mm Long Screws for Spinner (x2)
- M3 x 0.5mm Thread Lock Nuts for Spinner (x2)
- M3 x 0.5mm Thread x 12mm Long Scews for Cowling (x4)
- Pushrod Connectors like Nylon or Steel Kwik-Links (x5)
- Motor: Leopard 5065-7T
- ESC: 80A Esc
- Rec. Prop: 15 x 8 to 16 x 10
- Battery: 6S 5000mAh LiPo or 5S 5000 mAh
- Radio: Radio + 4 - 6 Channel Reciever
- Servos:
- EMAX ES3004 or EMAX ES3054 (x2) for Ailerons
- EMAX ES3004 or EMAX ES3054 (x2) for Elevators
- EMAX ES-3005 or Flite Test ES3005 or EMAX ES3001 (x1) for Rudder
- 4" Servo Extensions for aileron servos (x2) and 6" Servo Extensions for Receiver (x2)
Printed Parts Needed:
Wing Servo Cover L
3D
Aeroventures
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Wing Servo Cover R
Spinner 1
Spinner 2
- 4� -
Advertisement
