Advertisement
Step-by-Step Build Guide (cont'd)
Step 4.4 Glue Aileron Parts Together
4.4.1 Prior to gluing the aileron parts together, use the 1mm - 1.5mm
O.D. carbon fiber rod or steel rod to make sure it slides freely in the
hinge holes.
ATTENTION: The Rudder, Elevators and Ailerons are designed with separate Control
Horn parts. This was done in case you choose to print the control surfaces in LW-PLA
or LW-ASA. The Control Horn parts should be printed in a more rigid plastic like
4.4.2 Glue parts Aileron R1, Aileron Control Horn R and Aileron R2 together. The
Aileron Control Horn R is glued in between Aileron R1 and Aileron R2, as
shown in the image below. The built-in alignment aids will keep the parts
aligned. Ensure you have the control horn in the correct orientation
before gluing.
NOTE: To avoid confusion between
the Right side and Left side Aileron parts,
notice each individual part is labeled with it's
name. Aileron R4 and Aileron L4 are labeled
inside the hollow portion of the parts.
3D
Aeroventures
standard PLA, ABS, PETG, or PC for added strength.
Aileron R2
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Aileron Control Horn R
(PLA, ABS/ASA, or PETG)
Aileron R1
- 3� -
Advertisement
