Advertisement
Step-by-Step Build Guide (cont'd)
If you are painting your model, it is recommended to complete the following
2.3.6 The canopy is held in place with a spring loaded latch mechanism. The 4mm
O.D. spring can be purchased from the link provided or pulled from a click
pen or mechanical pencil. If needed, trim the spring to a length of 20 - 25mm.
2.3.7 Insert the Canopy Latch part into the slots located on the back of Canopy
Hatch 3. Insert the spring into the hole located on the end of the Canopy Latch.
2.3.8 Glue the Canopy Latch Cover into place. You'll see a slot in the Canopy Latch
Cover where the spring will insert. Ensure the Canopy Latch Cover is fully
seated to the back of Canopy 3. This will keep the spring slightly compressed.
BE EXTRA CAREFUL NOT TO GLUE THE CANOPY LATCH PART IN PLACE AND
IT IS FREE TO SLIDE BACK AND FORTH.
3D
Aeroventures
Canopy Latch steps AFTER painting the canopy.
(Image cropped for
illustrative purposes)
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
Canopy 3
Canopy Latch
Canopy Latch Cover
- 2� -
Advertisement
