Advertisement
Step-by-Step Build Guide (cont'd)
5.2.4 Apply glue to Tire Hub 1 in the areas that connect with Tire Hub 2, insert
Tire Hub 1 into the Tire and then insert Tire Hub 2 and spray with
Accelerator to speed up the bond. Repeat this step to assemble a second
tire.
5.2.4 If you are going to paintyour aircraft it is recommended that you paint the
landing gear struts/wheel pants prior to bolting on the wheels. Bolt the
wheels in place with the M5 x 40mm long pan head screws, using a washer
and M5 locknut on the inside of the wheel pant to secure the bolt in place.
Secure the 5mm wheel collar on the other side of the wheel
Wheel Collar for 5mm Shaft
3D
Aeroventures
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
M5 x 0.8mm Thread Lock Nut
M5 Steel Washer
M5 x 0.8mm Thread x 40mm Long Screw
- 4� -
Advertisement
