Advertisement
Step-by-Step Build Guide (cont'd)
8.1.5 Attach the 4" servo extenions to your aileron servos and, using the
mounting screws that came with your servos, mount the aileron servos to
the Wing Servo Covers.
Note: It is recommended to test and center the servos prior to installation.
8.1.6 Route the aileron servo wires through the servo cover openings in the
bottom of the wings and out the root of the wings. Use the M2 or #2 thread
forming screws to mount the Wing Servo Covers to the wings.
8.1.7 Cut the 12" aileron pushrods to the proper length and screw a nylon or
steel kwik-link into the threaded end. Attach the pushrods to the servo
control arms with a z-bend or with a pushrod connector, then attach the
kwik-links to the ailerons.
3D
Aeroventures
www.3daeroventures.com
w�w�3�A�r�v�n�u�e�.�o�
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 5� -
Advertisement
