Lubricating The Wheels - Hayter CODE610B Operator's Manual

4. Remove the blade, saving all mounting hardware
(Figure 26).
5. Install the new blade and all mounting hardware
(Figure 27).
Figure 27
Important:
Position the curved ends of the
blade to point toward the mower housing.
6. Use a torque wrench to tighten the blade bolt
to 45 N∙m.
Important:
A bolt torqued to 45 N∙m is very
tight. While holding the blade with a block of
wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This
bolt is very difficult to overtighten.

Lubricating the Wheels

Service Interval: Yearly or before storage
Apply a few drops of No. 2 lithium grease to the ball
bearings on each of the wheels
1. Ball bearings
g258238
18
(Figure 28).
Figure 28
g198657