Additional Information; Basic Commands; Group Identifier; Associations - 2gig Technologies EDGE Manual

Additional Information

Basic Commands

»
Basic Get commands to the EDGE panel will receive a response of Basic Report Value 0
»
Basic Set commands to the EDGE panel are ignored

Group Identifier

»
Only Group 1 is supported
»
Max number of devices per group: 1

Associations

»
Associations can be set by controllers with the ASSOCIATION_SET command
»
Associations supported commands:
»
COMMAND_CLASS_DEVICE_RESET_LOCALLY
»
DEVICE_RESET_LOCALLY_NOTIFICATION
NOTE: Associations are not controlled/supported through the EDGE UI .
S2
»
Supported Command Classes and Security Levels
NOTE: EDGE minimum required security level is none .

Controller Replication

Controller replication is not supported through the panel User Interface. Please consult your backend provider if the
replication option is available through the dealer portal.
Command Class
COMMAND_CLASS_ZWAVEPLUS_INFO
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_SECURITY
COMMAND_CLASS_SECURITY_2
COMMAND_CLASS_INCLUSION_CONTROLLER
COMMAND_CLASS_TRANSPORT_SERVICE_V2
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_CRC_16_ENCAP
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V3
COMMAND_CLASS_SUPERVISION
Version
Number
2
1
1
1
1
2
1
1
1
2
3
1