Siemens CLINITEK Status Operator's Manual page 82

5 Instrument Set Up
Instrument Settings
Authorized Operator
This section describes how to set up
use of operator IDs and add, edit, or
delete the list of operator IDs. When
enabled, the system permits only
allowed operators to perform patient
tests, QC tests (when using the
connector), recall results, or modify
system settings. Operators gain
access by entering their ID.
The Clinitek Status+ analyzer
stores 700 operators.
NOTE: The Operator ID is never
printed or displayed with patient
results. If you wish to associate the
Operator's Name with patient
results, enable Operator Name in
Custom Settings-Operator screen
1 of 5.
CAUTION
Once the Operator ID and Operator
Name settings are made, do not
change the Operator ID setting.
If you change the Operator
ID setting, all patient results are
erased.
Setting Operator IDs
To set up operator IDs, perform the
following steps:
1. At the Select Ready screen,
touch Instrument Set Up.
The Choose Settings screen
displays.
5-26
2. Use the arrow keys to select
Instrument Settings.
3. Touch Select.
The Instrument Settings screen
displays.