Siemens CLINITEK Status Operator's Manual page 77

5 Instrument Set Up
Instrument Settings
Connectivity
You can connect the instrument to
a PC or host computer, or, if you
have a Clinitek Status connector, to
an LIS using an Ethernet or
wireless network. If you are using
the connector, refer to the
Clinitek Status Connect System
Operator's Guide for more
information.
Allow results to be sent to PC
If enabled, the system
automatically sends both new and
recalled patient tests to a host or
LIS.
To automatically send new and
recalled patient results to the LIS or
a PC directly connected to the
system, touch Enabled.To prevent
sending new and recalled patient
results to the LIS or PC, touch
Disabled.
NOTE: If there is no connector,
Siemens recommends setting the
connector to Disabled setting.
Setting the connector to the
Enabled setting without a connector
may prevent communication with
an external system.
5-21