Powering Down - Siemens CLINITEK Status Operator's Manual

1
Unpacking & Set Up

Powering Down

Powering Down
1. Before turning the analyzer off,
always ensure that there is no strip
or cassette on the test table and
that the table and insert are clean.
2. Press the on/off button
at least 2 seconds. The test table
will retract into the analyzer. If there
is no strip or cassette on the test
table, the door will close and the
analyzer will switch off.
If a strip or cassette is still on the
test table, the test table will be
pushed out and the analyzer will
turn off. The test table will remain
out. In order to retract the test table
into the analyzer, turn the analyzer
on, and then off (without a strip or
cassette on the test table).
Do not push the test table fully
into the analyzer as the test table
may become jammed and prevent
the use of the analyzer.
1-8
for