Security Parameters - Alvarion BreezeACCESS VL System Manual

4.2.6.6.4.3 Maximum Number of Voice Calls
The Maximum Number of Voice Calls parameter sets the maximum number of
active calls in the cell.
The range is between 0 and 255.
The default value is 40.
4.2.6.6.4.4 DRAP TTL
The DRAP TTL parameter sets the time between two consecutive Allocation
Requests from the Gateways. The Allocation requests are used to identify the
existence of an active Gateway. In Voice Gateways they also include information
about the current number of voice calls and requests for new calls.
The range is between 1 and 255 (seconds).
The default value is 10 (seconds).
4.2.6.6.4.5 Number of Active Voice Calls
This option shows the current number of active voice calls in the cell.
4.2.6.6.5 Show Service Parameters
Displays the current values of the Service Parameters.
4.2.6.7

Security Parameters

BreezeACCESS VL systems can support encryption of authentication messages
and/or data frames using one of the following encryption standards:
WEP Wireless Equivalent Privacy algorithm. WEP is defined in the IEEE
802.11 Wireless LAN standard and is based on the RSA's RC4 encryption
algorithm.
AES OCB Advanced Encryption Standard. AES is defined by the National
Institute of Standards and Technology (NIST) and is based on Rijndael block
cipher. AES OCB (Offset Code Book) is a mode that operates by augmenting
the normal encryption process by incorporating an offset value.
FIPS 197 is certified for compliance with Federal Information Processing
Standards. It provides encryption and message integrity in one solution and
implements the Advanced Encryption Standard using Rijndael block cipher.
NOTE
The FIPS 197 encryption algorithm is a licensed feature, and is available only in units with the
required license. FIPS 197 can be supported only in Access Units with HW revision C or higher.
FIPS 197 feature license is not available for AUS unit.
Operation and Administration
Menus and Parameters
191