Alvarion BreezeACCESS VL System Manual page 266

Appendix E - BreezeACCES VL MIB
MIB Parameter
*MirOnlyOption
(*ServiceParameters 9)
*TrafficPrioritization
(*ServiceParameters 10)
*VLTrafficPriVLAN
(*TrafficPrioritization 1)
*LANPriorityThreshold
(*VLTrafficPriVLAN 1)
*TrafficPriIPToS
(*TrafficPrioritization 2)
*ToSPrioritizationOption
(*TrafficPriIPToS 1)
240
Description
Applicable only to AU. Not
applicable to BreezeNET B
products. When enabled, it
overrides the CIR/MIR
algorithm for determining
actual information rate and
forces the algorithm to
operate with MIR
parameters' settings only.
When enabled, the Graceful
Degradation algorithm is
disabled.
Traffic Prioritization
parameters. Applicable to all
units.
VLAN Prioritization
parameters. Applicable to all
units.
Applicable to all units. If the
VLAN Priority's value of the
frame is less than or equal
to this threshold, the frame
will get Low priority,
otherwise the frame will get
High priority. Untagged
frames will get Low priority.
ToS Prioritization
parameters. Applicable to all
units.
Applicable to all units.
Disable/Enable IP ToS
prioritization and chooses
the interpretation of the IP
ToS field from IP header:
ipPrecedence(2): The IP
ToS field is defined by
RFC791. In this case the
prioritization will be done
using the Precedence sub-
field of IP ToS. This sub-
field has 3 bits, so it can be
between 0 and 7.
dSCP(3): The IP ToS field is
defined by RFC2474. In this
case the prioritization will be
done using the DSCP sub-
field. The size of the sub-
field is 6 bits, so the range is
0 to 63.
BreezeACCESS VL System Manual
Value/Range
Integer
disable (1)
enable (2)
na (255)
Integer
0-7
Integer
disable(1),
ipPrecedence(2),
dSCP(3)