Alvarion BreezeACCESS VL System Manual page 93

Transmit Power
Maximum Tx Power (SU)
Tx Power (AU)
Antenna Gain (units with external
antenna)
ATPC Option
Best AU Support (SU)
Preferred AU MAC Address (SU)
Cell Distance Mode (AU)
Maximum Cell Distance (AU)
Fairness Factor (AU)
Per SU Distance Learning (AU)
Maximum Modulation Level (SU)
VLAN ID-Management
Commissioning
Table 3-1: Basic Parameters
Parameter Default Value
Dependent on HW
revision, unit type and
Sub-Band
Dependent on HW
revision and Sub-Band
On
According to the antenna
supplied with the unit and
the Sub-Band.
Enable
Disable
00-00-00-00-00-00 (none)
Automatic
0 (No Compensation)
100 (%)
Disable
8 (or the highest value
supported according to
the country code). No
higher than 7 for units
with HW revision A.
65535
Configuring Basic Parameters
Comment
Transmit Power in SU
cannot be higher than the
Maximum Tx Power
parameter.
Maximum Tx Power
cannot be higher than the
upper limit according to
the Sub-Band in use.
If set to "Not Set Yet",
must be configured
according to actual value,
taking into account
cable's attenuation.
Applicable only when
Best AU Support is
enabled.
Refer to section 3.4.
67