Configuring Basic Parameters - Alvarion BreezeACCESS SU-M-900 Installation Manual

Commissioning

Configuring Basic Parameters

The Basic Configuration menu of the Monitor program includes all the
parameters necessary for the initial operation of BreezeACCESS SU-M-900.
In many installations, many of these parameters should not be changed
from their default values.
Configuration of parameters that affect the hopping frequencies and
hopping mechanism depends on the configuration of the relevant AUs.
NOTE:
YOU MUST PERFORM A SITE SURVEY AND SPECTRUM SWEEP PRIOR TO CONFIGURING
THE AU'S IN ORDER TO DETERMINE THE AVAIABLE CLEAR CHANNELS.
The following list includes the basic parameters and their default values:
Parameter
IP Address
Subnet Mask
Default Gateway Address
DHCP Option
Access to DHCP
ESSID
Transmit Antenna
Hopping Channels
Scrambling Mode
Default Value
10.0.0.1
255.0.0.0
0.0.0.0
Disable
From Wlan Only
ESSID1
Antenna
915 MHz
Enhanced
Comment
Must be the same as the
ESSID the Base Station AU.
When HDM Mode in the AU
is enabled, configuring
these channels according to
site survey results will limit
the scan to these channels
only. If Scan Entire Band is
enabled (see below), then
this channel list will be
ignored.
If the roaming scan feature
is enabled, it is
recommended to configure
these channels according to
the deployment (see
Changes in HDM/Flexible
Hopping Definition
Parameters, on page 3-10).
Not applicable when HDM
Mode in the AU is enabled.
3-3