Alvarion BreezeACCESS VL System Manual page 121

Table 4-3: Parameters that are not reset after Set Partial Factory/Operator Defaults
Parameters Group
Bridge Parameters
Service Parameters
4.2.3.2.1.3 Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding several parameters that are listed in Table 4-2.
4.2.3.2.1.4 Set Partial Operator Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial
Operator Defaults are listed in Table 4-3.
Operation and Administration
Parameter
VLAN ID – Management
Service Provider VLAN ID (SU)
VLAN QinQ Protocol Ethertype
MAC Address List (AU)
MAC Address List Action (AU)
DRAP Option (AU)
UDP Port (AU)
Max Number of Voice Calls (AU)
DRAP TTL (AU)
Wireless Link Prioritization Option (AU)
Low Priority AIFS (AU)
Number of HW Retries for High Priority Traffic (AU)
Number of HW Retries for Low Priority Traffic (AU)
AU Burst Duration for High Priority Traffic (AU)
AU Burst Duration for Low Priority Traffic (AU)
SU Burst Duration for High Priority Traffic (AU)
SU Burst Duration for Low Priority Traffic (AU)
Low Priority Traffic Minimum Percent
Menus and Parameters
95