Alvarion BreezeACCESS VL System Manual page 257

MIB Parameter
*CurrentFrequencySubset
FrequencyNew
(*FrequencySubsetEntry 3)
*CurrentAUOperatingFrequency
(*FrequencyDefinition 7)
*AUDefinedFrequency
(*FrequencyDefinition 8)
*CurrentSUOperatingFrequency
(*FrequencyDefinition 9)
*SubBandSelect
(*FrequencyDefinition 10)
*SelectSubBandIndex
(*SubBandSelect 1)
*DFSParameters
(*FrequencyDefinition 11)
*DFSOption
(*DFSParameters 1)
BreezeACCESS VL System Manual
Description
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Read-only. The frequency in
MHz of an entry in the Current
Frequency Subset table. (Replaces
*CurrentFrequencySubsetFrequency
to support a resolution of 0.5 MHz
for units with HW revision C and
higher).
Applicable to AU/BU with HW
revision B and lower (for units with
HW revision C and higher replaced
by
*CurrentUOperatingFrequencyNew
to support a resolution of 0.5 MHz).
Read-only. The operating frequency
in MHz.
Applicable to AU/BU with HW
revision B and lower (for units with
HW revision C and higher replaced
by
*DefinedAUOperatingFrequencyNew
to support a resolution of 0.5 MHz).
Read-only. For 5.8 GHz products
with SW version below 2.0 this is the
frequency in MHz of the AU/BU after
the next reset.
For units with SW version 2.0 and up
this is the frequency in MHz to use
when the DFS Option is disabled.
Applicable to SU/RB. Read only.
The current operating frequency in
MHz.
Sub-Band Selection parameters
Applicable to all units. Read only for
SU/RB with SW version 4.0 and
higher. The ID of the sub-band used
by the unit.
DFS Parameters. Applicable to
AU/BU.
Applicable to AU/BU.
Enabling/disabling the DFS
Algorithm. Not applicable if DFS
Option is not supported by the
current Sub-Band.
breezeAccessVLMib
Value/Range
DisplayString
Integer
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10 MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
Integer
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10M Hz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
DisplayString
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10 MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
Integer
Integer
disable (1)
enable (2)
na (255)
231