Table of Contents
Advertisement
Aligning the Antenna
Once the antenna is mounted and the LB NI-01 Indoor unit is installed,
the antenna must be aligned in both the azimuth and elevation planes.
Elevation alignment is accomplished by loosening the two bolts
attached to the mounting bracket, as shown in Figure 15 below, and
angling the antenna so it is aligned towards the remote BreezeACCESS
LB unit.
The azimuth alignment is accomplished by loosening the bolts on the
antenna bracket, and rotating the antenna until alignment is achieved.
For basic tuning using actual signal strength, an alignment "buzzer"
(intermittent tone sweep generator) is available in the LB RE-01
Outdoor unit. Faster repetitions of the tone sweep indicate better
alignment. The buzzer is enabled via the software interface described in
the
Commissioning
Azimuth
Adjustment
Bolts
Figure 2-15: Aligning the Antenna - Vertical Mount
Chapter of this manual.
Aligning the Antenna
Elevation
Adjustment
Bolts
2-17
Advertisement
Table of Contents
Troubleshooting
