Table of Contents
Advertisement
Command
flowctrl
gateway
http
ipaddr
ipmask
macaddr
master
modreduct
radio
reboot
rfchannel
save config
snmp
sysdetails
sysname
telnet
telnetport
test config
Table C-4: System Configuration
Description
Specifies whether flow control on the Ethernet
port is enabled
Specifies the IP address of the default router
Specifies whether configuration over HTTP is
enabled
Specifies the IP address used by the local
terminal
Specifies the IP Subnet Mask used by the local
terminal
Specifies the Ethernet MAC address used by the
local terminal
Indicates whether the system is serving as the
master or slave
Used when 'AdaptMod' is disabled.
Specifies whether radio transmission is enabled
Reset all statistics and reboot the terminal
Available channel options: 1, 1A, 2, 2A, 3, 3A, 4,
4A, 5.
Permanently saves configuration settings
Specifies whether configuration over SNMP is
enabled
Specifies the location, telephone #, contact
information, etc.
Identifies the local terminal
Specifies whether configuration over telnet is
enabled
Specifies the TCP port used for telnet
Allows testing of new settings for 5 minutes, after
which system reverts to previously saved
settings. Use 'Save' for permanent settings.
System Status and Configuration
C-7
Advertisement
Table of Contents
Troubleshooting
