To help you establish other implementations that are not addressed in
this manual, Figure 10 provides an illustration of the pin-out for the LB
NI-01 Indoor unit LAN interface.
Warning: do not connect a telephone cable to the LB NI-01 LAN
interface, as this will damage the LB NI-01 Indoor unit.
Figure 2-10: Indoor unit LAN Ethernet Port RJ-45 Jack
Table 2-1: Indoor unit LAN Ethernet Port Pin-out
Jack Pin
1
2
3
6
Now connect the AC cord to the 110/220/240 VAC outlet and turn on
the LB NI-01 using the toggle switch in the rear of the unit. The system
"Pwr" LED should illuminate green to indicate power to the unit. The
system is now ready to be configured. If the Pwr LED is not on and/or
the "Fault" LED illuminates red, there is a problem with the LB NI-01.
Refer to the
Diagnostics and Troubleshooting
further details on system faults.
Installing the Indoor Unit
Function
Rx +
Rx -
Tx +
Tx -
chapter of this manual for
2-11