Appendix C - CLI Commands
Command
swver
sysname
txpower
ubrate
wrxpkt
wrxpktd
wrxpktr
Wtxpkt
wtxptd
wtxpktr
System Configuration
Command
adaptmod
buzzer
chgver
encrypt
encryptkey
C-6
Table C-3: System Status
Description
Specifies the operating software version
Identifies the local terminal
The actual current transmit power level
Indicates the system's current uncoded burst
rate
The no. of successful wireless pkt. received over
the air
The no. of wireless pkt. received with errors over
the air
The no. of wireless pkt. retransmitted over the air
The no. of wireless pkt. successfully transmitted
over the air
The no. of transmitted pkt. discarded by the
remote terminal
The no. of wireless pkt. retransmitted over the air
Table C-4: System Configuration
Description
Enables Adaptive Modulation mode.
Specifies whether the antenna buzzer is enabled
Change the operating software version
Specifies whether over-the-air data encryption is
enabled
Enter the remote terminal's MAC address if
encryption is enabled
BreezeACCESS LB System Manual