System Status
System Status
Clicking on System Status in the main menu will load this page, which
provides General Information, Ethernet LAN Statistics and Wireless
Statistics, as shown in Figure 3-10 below.
Figure 3-10: System Status
General Information: Identical to the information found on the General
Information page, with the addition of:
RF Channel Frequency: Specifies the center frequency of the channel
in use.
Tx Power: Specifies the actual current transmit power level.
Cable Attenuation: Indicates the attenuation of the 800 MHz signal
over the IF cable. This value cannot exceed 14 dB of attenuation. Check
cable length and verified cable type. Refer to Specification section for
details.
RF Status: An error code from 0-31 indicating the condition of the RF
components within the LB NI-01 Indoor unit and LB RE-01 Outdoor
unit. See the RF Status Error Code table below for details.
3-17