Table of Contents
Advertisement
Working with programs
The program memory offers the opportunity of storing
and recalling a maximum of 9 individual centrifugation
runs.
Program display
Depending on the kind of operation the 3 following
symbols can appear:
[
] normal run with set values of the operating
memory
[ 1 ] (respectively 2 ... 9) run with program 1 ... 9
[
] quick run
The symbols stay after completion of the run, so that
the kind of operation recalled last can be seen.
If the rotor starts with a program, the speed or rcf set
value of which is impermissibly high or the rcf set
value of which lies below the rotor specific minimum
value, the display in the program panel will change to
[
] after identification of the rotor.
Entering / changing a program
From the manufacturer all the program places 1 to 9
have been preset with the same values.
For a change please follow this procedure:
Select memory place number with the program
selection key:
memory place number flashes.
Open the program memory by actuating the pro-
gram memory key (possible only, if the memory
place number flashes):
all the pre-selection displays flash.
Desired parameters may be put in:
only the altered pre-selection display flashes.
After setting all set values, please wait a short
time, until all preset values are flashing commonly
again.
By actuating the program memory key, the pro-
gramming has been completed:
memory place number flashes; thereafter the
program has been set.
For the setting of further memory places the proce-
dure has to be repeated accordingly.
Operation
57
Advertisement
Table of Contents
Troubleshooting
