Table of Contents
Advertisement
Operation
Selecting run time
The run time setting consists of two setting ranges:
Up to a value of 9 min 59 sec setting is done in steps
of seconds. Above 10 min up to 99 min run time is set
in steps of minutes.
Additionally, there is the possibility of operating the
centrifuge continuously (hold).
Fixed run time
To set a fixed run time, proceed as follows:
1. Press one of the "set" keys
(for a decrease) in the "run time" section of the
control panel once to switch from the actual to the
set value mode.
2. By briefly pressing the "set" key you can now
52
(for an increase) or
raise or lower the run time
step by step.
3. If you keep the selected key pressed, the display
changes continuously and slowly and after a few
seconds at an accelerated pace up respectively
down.
4. Release the key as soon as you have reached the
desired value, and adjust if necessary by repeat-
edly pressing the key. The time display flashes for
a few seconds, then changes to permanent dis-
play. The run time is stored now.
You may shift the flashing cursor to set the value as
described for speed selection (see above).
Continuous operation
In order to set the Cryofuge
ous operation please press one of the time set keys
until the display shows "hold".
With this setting, the centrifuge
keeps running until stopped
manually with the "stop" key
5500i GMP to continu-
®
.
Advertisement
Table of Contents
Troubleshooting
