Property 0X05 - Track Id Enable (Msr Only) - Magtek eDynamo Programmer's Manual

9 - Properties
9.7

Property 0x05 - Track ID Enable (MSR Only)

0x05
Property ID:
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x95
This property is defined as follows:
Bit Position
id = 0: Decodes standard ISO/ABA cards only
id = 1: Decodes AAMVA and 7-bit cards also
If the id flag is set to 0, only tracks that conform to the ISO card data format allowed for that track are
decoded. If the track cannot be decoded by the ISO method, the device reports a decode error.
For each pair of track bits, valid values are as follows:
T = 00: Track Disabled
#
T = 01: Track Enabled
#
T = 10: Track Enabled and Required (Error if blank)
#
This property is stored in non-volatile memory, so it persists when the device is power cycled. When this
property is changed, the device must be reset (see Command 0x02 - Reset Device) or powered off for at
least 30 seconds, then powered on, before the changes will take effect.
Example Set Request (Hex)
Cmd Num
01
Example Set Response (Hex)
Result Code
00
Example Get Request (Hex)
Cmd Num
00
Example Get Response (Hex)
Result Code
00
eDynamo| Secure Card Reader Authenticator | Programmer's Manual (COMMANDS)
7 6
id 0 T
3
Data Len
02 05
Data Len
00
Data Len
01 05
Data Len
01 95
Page 140 of 245 (D998200115-17)
5 4 3
T T
3 2
Property ID
Data
Property ID
Property Value
2 1 0
T T T
2 1 1
Property Value
95