Magtek eDynamo Quick Installation Manual

CAUTION: MagTek recommends charging the batteries on
arrival AND charging the batteries at least every 6 months.
STORAGE TEMPERATURE: 32°F to 113°F (0°C to 45°C)
eDynamo gives users the flexibility needed to securely accept a variety of
payment card technologies. Whether accepting a traditional magnetic stripe
card or a contact EMV card, eDynamo gives merchants the ability to connect
via USB or Wireless, delivering one reader for mobile or stationary needs.
This design leads to saving the user money on a single, low-cost, yet highly
secure device.
Major Components
Power and Charging
Power: via micro-USB (utilize its wired USB interface and power to operate
while connected to a PC or tablet-based POS system where a USB Host and
power are available) or via the rechargeable battery.
Charging: Fully charge eDynamo before first use (for 3 hours or until the LED
is solid green). Fully charge eDynamo within 6 months of shelf storage.
Charging via industry standard USB cables. Requires USB port for charging
before use. Subsequent charging requires just a couple of hours for a full
charge. Allows over 1,000 card swipes between charges.
Device Modes
•
Airplane Mode: ship mode, will not advertise/communicate over Wireless.
•
Reset Mode: to reset to Airplane Mode, hold the pushbutton for 5 to 10
seconds.
•
Discoverable Mode: press the pushbutton briefly to get to this waiting/
ready state. Device is not connected to USB but advertises over Wireless.
•
Pairing Mode: to pair the reader via Wireless, hold the pushbutton for
two seconds, the LED will flash three times, release the pushbutton. The
device will advertise over Wireless and the Wireless Status LED will flash
once every two seconds. Find and pair on the terminal.
•
Connected Mode: connected to a USB host, or paired to Wireless host,
the device does not advertise and is not discoverable.
•
Tamper Mode: self-test has failed or a tamper has been detected, the
device must be returned to manufacturer for a factory reset.
EMV/Secure Card Reader Authenticator
Quick Installation Guide
Setup and Installation
MagTek Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 651-415-6800 | f 562-546-6301 | www.magtek.com
®
eDynamo - PN 21079809
Connection
•
Micro-USB B: configured to appear as a vendor-defined HID device, no
custom drivers necessary.
•
Wireless: configured to appear as a GATT device. Supports personal
area network using standard 2.4GHz frequency space
•
Wireless Range: Minimum 33 ft. (10 m) in line-of-sight conditions.
Mounting
eDynamo offers versatile mounting options and can be mounted or hand
held. It requires no wire management or hole drilling.
Optional Docking Station
With the optional docking station for surface-mounted applications,
simply press eDynamo onto any smooth, clean surface. The micro-suction
base offers the optimal level of stickiness so cardholders can swipe with
confidence without requiring any mounting hardware or alterations to the
mounting surface. In addition, the docking station includes recessed panels
to apply your own branding. Connect the USB cable to eDynamo. Place
eDynamo on the base. Then connect the top case over eDynamo connecting
to the base.
Tested Operating Systems
iOS 7.1 and above, Android 4.4.2 and above, USB: Win 7, Win 8.1, Win 10