Table of Contents
Advertisement
100165 - 7500W DUAL FUEL ELECTRIC START GENERATOR
ASSEMbLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold
each side flat on the ground to provide a surface area to work
with the generator.
Install the Wheel Kit
The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Before adding fuel and oil, tip the generator onto it's recoil
end.
2. Slide the roll pin through the wheel from the outside.
3. Slide the roll pin through the mount point on the frame.
4. Secure with the r-clip.
5. Repeat to attach the second wheel.
CAUTION
Install the Support Leg
1. Attach the support leg to the generator frame with flange
bolts and flange lock nuts.
2. Slowly tip the generator back down so that it rests on the
wheels and support Leg.
Connect the battery
1. Remove the protective cover from the red (+) lead on the
battery.
2. Attach the red (+) lead to the red (+) terminal on the battery
with the bolt and secure with the nut.
3. Repeat for the black (–) battery lead.
Add Engine Oil
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
The recommended oil type for typical use is 10W-30
automotive oil. However, using the listed conventional oils
shown in the "Recommended Engine Oil Type" chart may be
used for typical use including the first 5 hours of the break-in
run time period of the engine.
If running generator in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
14
ASSEMbLY
WARNING
NOTICE
NOTICE
Advertisement
Table of Contents
