Assembly; Unboxing; Install The Wheel Kit; Install The Support Leg - Champion 100397 Operator's Manual

100397
ENGLISH
Your generator requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the assembly of your
generator, call our help line at 1-877-338-0999. Please
have your serial number and model number available.

Unboxing

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road use.
1. Before adding fuel and oil, tip the generator on it's side.
2. Slide the wheel pin roll through the wheel from
the outside.
3. Slide the wheel pin roll through the mount point on
the frame.
4. Secure with the R-Pin Ø2 x 33.
5. Repeat steps 2-4 to attach the second wheel.

Install the Support leg

1. Attach the support leg to the generator frame with
flange bolts (M8x16) and flange lock nuts.
2. Tip the generator slowly so that it rests on the
wheels and support leg.

Install the Handle

1. Place the handle over the mounting channel on the
frame.
2. Secure the handle to the frame using the two flange
bolts (M8x45).
3. Place a flange lock nut on the end of each bolt and
fasten securely. DO NOT over tighten the flange lock
nuts.

Connect the Battery

1. Remove the protective cover from the red (+) lead on
the battery.
2. Attach the red (+)lead to the red (+) terminal on the
battery with the cap screw and secure with the nut.
3. Repeat steps 1-2 for the black (–) battery lead.

ASSEMBly

10