Table of Contents
Advertisement
93001i-UK - 3000W PORTAbLE INvERTER GENERATOR
ASSEMbLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of
your generator, call our Technical Support Team at
+44(0)-1942-715-407. Please have your serial number and model
number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Using the carrying handles of the unit, carefully remove the
generator from the box (two people lifting is recommended).
Add Engine Oil
A
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
The recommended oil type for typical use is 10W-30
automotive oil. However, using the listed conventional oils
shown in the "Recommended Engine Oil Type" chart may be
used for typical use including the first 5 hours of the break-in
run time period of the engine.
If running generator in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
Recommended Engine Oil Type
5W-30
5W-30 Full Synthetic
°F
-20
0
20
°C
-28.9
-17.8
-6.7
Ambient temperature
CAUTION
NOTICE
NOTICE
10W-30
10W-40
40
60
80
100
4.4
15.6
26.7
37.8
1. Place the generator on a flat level surface. Do Not angle or tip
the generator when adding oil.
2. Loosen the four cover screws and remove the maintenance
cover.
3. Remove oil fill cap/dipstick to add oil.
4. Using a funnel, add up to 16.9 fl. oz. (500 ml) of oil and
replace oil fill cap/dipstick and secure maintenance cover. DO
NOT OVERFILL.
When using the dipstick to check oil level, DO NOT screw in
the dipstick while checking, simply rest it against the top of
the port.
As a general rule oil is full when it can be seen visually on the
middle to upper threads of the port. Do Not angle or tip the
generator when adding oil.
5. Check engine oil level before each use and add as needed.
MAX
120
48.9
15
ASSEMbLY
NOTICE
OIL DIP STICK
Advertisement
Table of Contents
