Table of Contents
Advertisement
201319 - 4500W DUAL FUEL ELECTRIC START INVERTER GENERATOR
ASSEMbLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Using the carrying handles of the unit, carefully remove the
generator from the box (two people lifting is recommended).
Remove Shipping Support Hardware
To protect the generator during shipping, support hardware has
been installed between the engine and frame. This hardware
MUST BE REMOVED BEFORE adding oil or gasoline to the
generator.
DO NOT attempt to run generator without first removing the
shipping support hardware. Damage to the generator as a result
of not removing the hardware will void the warranty.
1. BEFORE filling the engine with oil or gasoline, tip the
generator onto the muffler side. Tip onto the flattened
cardboard box the generator came in or other protective
surface so as to not scratch the enclosure.
2. Remove the two bolts, four nuts and mounting plates from
the bottom side of the generator using the included 8/10 mm
wrench. Bolts, nuts and spacers can be discarded.
3. Tip the generator upright.
NOTICE
Connect the battery
1. Remove the non recoil side maintenance cover by removing
the two screws with a Phillips head screw driver
(included).
2. Push two halves of battery connector together tightly.
Add Engine Oil
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
The recommended oil type for typical use is 10W-30
automotive oil. However, using the listed conventional oils
shown in the "Recommended Engine Oil Type" chart may be
used for typical use including the first 5 hours of the break-in
run time period of the engine.
If running generator in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
Recommended Engine Oil Type
5W-30
°F
-20
0
°C
-28.9
-17.8
-6.7
19
WARNING
NOTICE
NOTICE
10W-30
10W-40
5W-30 Full Synthetic
20
40
60
80
100
4.4
15.6
26.7
37.8
Ambient temperature
ASSEMbLY
120
48.9
Advertisement
Table of Contents
