Table of Contents
Advertisement
100430 - 6500W ELECTRIC START GENERATOR
ASSEMBLY
Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold
each side flat on the ground to provide a surface area to work
with the generator.
Install the Wheel Kit
The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Before adding fuel and oil, tip the generator onto it's recoil
end.
2. Remove wheel hub cap (B) from wheel by inserting a small
screwdriver into the slot provided and pry upward.
3. Slide the roll pin (C) through the wheel (A) from the outside.
4. Slide the roll pin through the mount point on the frame.
5. Secure with the r-clip (D).
6. Re-install hub cap on wheel.
7. Repeat to attach the second wheel.
A
C
D
B
CAUTION
Install the Support Leg
1. Attach the support leg (E) to the generator frame with flange
bolts (F) and flange lock nuts (G). DO NOT OVERTIGHTEN.
Frame tube will deform if flange nut is overtightened.
2. Slowly tip the generator back down so that it rests on the
wheels and support Leg.
Connect the Battery
1. Cut cable tie on each side of battery connector.
2. Push two halves of battery connector together tightly.
Install the Lifting Hook
1. Attached the lifting hook (H) to generator frame with two
flange bolts (I).
2. Tighten bolts securely to a torque of 17-22 ft-lbs.
17
G
E
F
H
I
ASSEMBLY
Advertisement
Table of Contents
