Akai MPC 3000 Operator's Manual page 89

Chapter 4: Editing Sequence
Loop
• The field:
In this field enter the loop status (
number, if TO BAR is selected, for the initialized sequence.
The "Track" section
• The Track field:
Any or all of the sequence's tracks can be initialized. To enter the
settings for each track, first select the track number in this field,
then enter the initialization data for that track in the fields below.
The contents of the five fields in this section apply only to the track
(1 of 99) that is selected in this field.
• The Status field:
This is a choice field with two options:
UNUSED
1. : The track number displayed in the
will not be initialized. Instead, it will be set to an unused
state (as when power is turned on), which requires the
least amount of memory. However, if this track is later
recorded into, it will immediately be initialized to default
values.
2. IN USE : The track number displayed in the
will be initialized to the values entered in the
and Chn fields.
Type
• The field:
Type
The field for the selected track will be initialized to the option
selected in this field ( DRUM
Pgm
• The field:
Pgm
The field for the selected track will be initialized to the option
selected in this field (1-128 or OFF).
Chn
• The field:
In this field enter the output MIDI channel (1-16 or OFF) and port
(A-D) to which the selected track will be initialized, using the same
data entry method as in the
the right of this field is another field for the auxiliary MIDI output
channel assignment.
<Do it>
• The soft key:
After values for all the fields have been entered, press this soft key
to initialize the sequence.
Page 76
OFF or TO BAR
or MIDI ).
Chn
field in the Play/Record screen. To
) and the loop bar
Track
field
Track field
Type Pgm
,