Loading A Seq File (Single Sequence) - Akai MPC 3000 Operator's Manual

Loading a SEQ File (Single Sequence)

To select a different disk device, choose it in the
press the <Select it>
FLOPPY DISK
HARD DISK PART A
HARD DISK PART B
HARD DISK PART C
(and other hard disk partitions if they exist)
When <Select it>
redisplayed and the selected disk device will be active.
If a SEQ file is selected and
following screen, in which you are asked which sequence number to
load the sequence into:
===== Load a Sequence file (.SEQ) ======
Load into sequence:02-Sequence_name___
========================================
<Load it>
Select the sequence number to load the file into, then press
<Load it> .
If the file is an MPC60 version 1 or 2 SEQ file
If the SEQ file is a MPC60 version 2 file, additional screens are
presented:
=========== Load V2 SEQ File ===========
Each drum note s pad assignment must be
converted to a MIDI note number using
the editable table in the next screen.
To standardize note-to-instrument
assignments, use general MIDI numbers.
========================================
<Next screen>
After pressing <Next screen>
Page 175
Chapter 9: Saving to and Loading from Disk
soft key. The options are:
is pressed, the previous screen will be
<Load it> is pressed, you'll see the
:
Disk
field, then