Akai MPC 3000 Operator's Manual page 74

Last Punch In=
• The
These two fields are indicators only—they cannot be manually
changed. They are used to indicate the exact locations of the
punch-in and punch-out that was last performed manually.
• The <Turn on >
Pressing this turns on the Auto Punch function, as indicated by
the status light above the key. If Auto Punch is already on, the
soft key text shows <Turn off>
Auto Punch and the light off.
• The <Use 'Last'>
Pressing this soft key causes the contents of the
In= Out=
and fields to be copied into the
Out=
and fields. This is useful when you want Auto Punch to
automatically repeat the last manual punch.
To perform the AUTO PUNCH:
Once you have entered the punch-in and punch-out locations and
you have turned Auto Punch mode on by pressing SOFT KEY 1,
locate to a position within the sequence that is a few bars before
the punch-in point. Then enter Record mode as usual by pressing
PLAY and RECORD simultaneously. Since the Auto Punch
function is on, however, Record mode is not yet entered. Instead,
the RECORD light blinks until the punch-in point is reached.
When it is reached, Record mode is automatically entered and
the RECORD light stops blinking and stays on continuously.
When the punch-out point is reached, Record mode is automati-
cally exited and the RECORD light goes off, but play continues.
It is also possible to use Auto Punch to enter and exit Overdub
mode automatically. To do this, follow the example given above,
but instead of pressing RECORD, press OVERDUB. The mode
that is entered is determined by which key is pressed, RECORD
or OVERDUB.
Page 61
Chapter 3: Recording Sequences
Out=
and fields:
soft key:
and pressing it turns both
soft key:
Last Punch
Auto Punch In=