P.
Procedure
1.
2.
3.
4.
Reference Manual
Heater strut assembly
Before installing sample block heater rods (E,
rods with Watlube heater release agent.
If thermal switch (K) was removed, install thermal switch on mating heater clamp
(L), connect wires of heater rods (E), and install insulator (I).
Install the heater rods (E), heater clamps (L), and screws (N).
Reconnect the heater rod leads at the housing terminal blocks
Maintenance and service
Figure
9-20), evenly coat the heater
(Figure
9-21).
245