Emerson Rosemount OCX 8800 Reference Manual page 253

11.
12.
Install sample block heater rods
Complete the following steps to install the sample block heater rods in the OCX 8800.
Reference Manual
Figure 9-19: COe sensor, thermocouple, and heater connections
A. All wires at these terminals are in the CJC current loop.
Install and fasten the COe insulator (A,
(I).
All wiring must remain outside of the insulator.
If terminal block mounting (F,
mounting screws.
Figure 9-15) around the COe sensor assembly
Figure 9-15) was moved, reinstall it with two base
Maintenance and service
243