Setting The Pressure Point On A Magura Brake Lever - Bosch Kiox Original Operating Instructions

 The brake handle moves closer to the
handlebars.
 The brake linings move closer to the rim.
 The pressure point activates sooner.
 Move the slider inwards (+) to Position II or I.
 The brake lever moves away from the
handlebars.
 The brake linings move away from the rim.
 The pressure point activates later. Adjusting
the grip distance on a Magura disc brake lever
Only applies to pedelecs with this equipment
WARNING
!
Crash caused by incorrectly set grip distance
If brake cylinders are set incorrectly or installed
wrongly, the braking power may be lost at any
time. This may cause a crash with injuries.
 Ensure that the fully applied brake lever is at a
minimum distance of 20 mm from the
handlebars (4).
You can adjust the brake lever position (grip
distance) to your requirements. Such adjustment
does not affect the pressure point or the position
of the brake linings.

Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
Figure 62: Setting the grip distance on a Magura disc
brake lever
 Turn the setting screw/twist knob (5) anti-
clockwise towards minus (–).
 The brake lever moves closer to the handlebar
grip.
 Turn the setting screw clockwise towards
plus (+).
 The brake lever moves away from the
handlebar grip.
MY21P01 - 22_1.0_24.09.2020
6.5.4.4 Setting the pressure point on a
Magura brake lever
WARNING
!
Brake failure due to incorrect setting
If the pressure point is set with brakes where the
brake linings and brake disc have reached their
wear limit, the brakes may fail and cause an
accident with injury.
 Before you set the pressure point, ensure that
the brake linings and brake disc have not
reached their wear limit.
The pressure point setting is adjusted using the
twist knob.
 Turn the twist knob towards the plus (+)
symbol.
 The brake lever moves closer to the handlebar
grip. Re-adjust the grip distance as necessary.
 The lever pressure point activates sooner.
1
Figure 63: Using the twist knob (1) to adjust the pressure
point
Operation
57