On-Board Computer; Usb Port; Control Panel; Riding Light - Bosch Kiox Original Operating Instructions

3.1.6

On-board computer

Figure 12: Kiox on-board computer
The on-board computer displays the main drive
system functions and the ride data. The drive
system can be switched off by removing the on-
board computer. The pedelec's battery powers the
on-board computer if the on-board computer is
inserted in the mount, a sufficiently charged
battery is inserted into the pedelec and the drive
system is switched on. If the on-board computer is
removed from its mount, power is supplied from
the on-board computer rechargeable battery. If
the on-board computer battery is low, a warning
message is shown on the screen. If the on-board
computer is removed from its mount and not
switched off, information on the last trip distance
travelled and status information will be displayed
after one another in a loop. If no button is pressed
after its removal from its mount, the on-board
computer will switch off after 1 minute. The date
and time will be maintained for a maximum of
three months without needing to charge the
display battery. When it is switched on again, the
date and time will be reset if there is a Bluetooth®
connection to the app and successful GPS
localisation on the smartphone. Registration or
log-in is required on the eBike Connect portal or
the eBike Connect app to log activities. You need
to agree to location data being saved on the portal
or the app to log activities. Only then will your
activities be displayed on the portal or app. Your
location will only be logged if the on-board
computer is connected to the eBike Connect app.
MY21P01 - 22_1.0_24.09.2020

3.1.6.1 USB port

There is a USB port under the rubber cover
beneath the on-board computer.
Charge voltage
Charging current
Table 9: USB port technical data
The USB connection can be used to operate or
charge most devices which can be recharged via
USB, such as different mobile telephones. The
on-board computer and a sufficiently charged
battery must be in use on the pedelec to charge
devices.
3.1.7

Control panel

The on-board computer is controlled using the 6
buttons on the control panel on the handlebars.
Figure 13: Control panel
3.1.8

Riding light

When the riding light is activated, the headlight
and the rear light are switched on together.
3.1.9

Charger

Each pedelec is supplied with a charger. As a
general rule, any BOSCH charger may be used:
• The 2 A compact charger
• The 4 A standard charger
• The 6 A fast charger
Observe the operating instructions in the section
on Documents.
Overview
5 V
Max. 1000 mA
21