Additional Eshift System Setting; System Message; Abs Indicator Lamp - Bosch Kiox Original Operating Instructions

3.5.2.7

Additional eShift system setting

Only applies to pedelecs with this equipment
The following additional functions are available on
the function display:
Indicator
SE T ST AR T G EAR
Table 24: Additional journey information
Applies only to pedelecs with eShift with Shimano
DI2 derailleur gears. The following additional
functions are available on the function display:
Indicator Change
A DJ U ST G EAR This is where you can make a fine
adjustment to the Shimano Di2.
You'll find the specified setting
range in the gear manufacturer's
operating instructions. Make the
fine adjustment as soon as you
hear any unusual noises from the
gear shift.
Table 25: Additional journey information
Applies only to Pedelecs with eShift with NuVinci
H|Sync/ enviolo with Optimized H|Sync
The following additional functions are available on
the function display:
Indicator
C AL IBR AT IO N
Table 26: Changing the system settings
3.5.2.8

System message

The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error. You
will find assistance for system messages in
Section 8.5 Initial help. There is a table of system
messages in the Appendix.
MY21P01 - 22_1.0_24.09.2020
Change
You can change the gear in this
menu option.
Change
This is where you can perform
a calibration on the stepless
gear. Follow the instructions on
the display.
3.5.2.9

ABS indicator lamp

Only applies to pedelecs with this equipment
The ABS indicator lamp must light up after the
system has started up and must go out once
speed has reached about 5 km/h. If the ABS
indicator lamp does not light up when the electric
drive system starts, the ABS is defective. An error
code on the display also tells the rider that it is
defective.
Figure 17: ABS error message on the Kiox display
If the indicator lamp does not go out after you set
off or it lights up while you are riding, this means
there is an error in the ABS. The ABS is then no
longer active. The brake system itself will continue
to work. It is only the ABS control which no longer
works.
If the ABS indicator lamp is lit, the ABS function is
not active.
Notice
The ABS indicator lamp may light up if the front
and rear wheels are rotating at widely different
speeds from one another – for example, if the
rider manoeuvres on the rear wheel only or if a
wheel is rotating for a unusually long time without
making contact with the ground (fitting stand).
The ABS will switch off at such times.
Stop pedelec, switch off and restart to reactivate
the anti-blocking system.
Overview
31