Preparing The Battery; Checking The Battery; Retrofitting A Powertube; Adapter 400 Or 500 - Bosch Kiox Original Operating Instructions

5.4

Preparing the battery

5.4.1

Checking the battery

The battery must be checked before it is charged
for the first time.
1 Press the On-Off button (battery).
 If none of the LEDs on the battery level
indicator light up, the battery may be damaged.
 The battery may be fully charged if at least one,
but not all, of the LEDs on the battery level
indicator is lit up.
5.4.2

Retrofitting a PowerTube

Adapter 400 or 500

A PowerTube Adapter 400 or 500 needs to be
retrofitted to use a Bosch PowerTube 625 battery.
1 Use a TORX® T25 wrench to undo the screws
in the battery mount.
Figure 22: Undoing screws on battery mount
2 Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter. If you don't
have a ratchet, you can use a hexagonal key to
remove the screws.
Figure 23: Removing the 4 mm hexagon screws
MY21P01 - 22_1.0_24.09.2020
3 Use a ratchet to remove the two 4 mm hexagon
screws in the PowerTube adapter.
Figure 24: Removing hexagon screws
4 Pull out the PowerTube adapter.
Figure 25: Pulling out the PowerTube adapter
5 Use adapter plates to adjust the distance if
necessary.
Figure 26: Fitted adapter plates
Assembly
40