5.4.4
Fit battery cover onto Bosch
PowerTube 500 battery (horizontal)
1 Detach the upper interface (lock side) from the
Bosch PowerTube 625 battery with a TORX®
T20 wrench.
Figure 31: Detaching the upper interface
2 Fasten the PowerTube extension to the Bosch
PowerTube 500 battery using the two
M4 x 8 T20 screws supplied. In doing so,
ensure that the closed side faces the front of
the battery (towards on-off switch). The
smooth upper surface of the PowerTube
extension must face upwards, away from the
battery.
Figure 32: Fitting the PowerTube extension
3 Screw the battery mounting plate onto the
PowerTube extension with original Bosch
screws (M4 × 8 T20). To do so, use the
PowerTube extension screw plate as a counter
support. When positioning the extension,
ensure that the removal tab faces the front of
the battery.
MY21P01 - 22_1.0_24.09.2020
.
Figure 33: Fastening the battery mounting plate
4 Press to push the battery cover onto the
battery. In doing so, ensure that the battery on-
off switch fits through its designated slot in the
cover.
Figure 34: Pushing the battery cover onto battery
The battery cover will lock into the fitting
grooves on the battery.
The battery can now be inserted into the frame.
5.5
Preparing the on-board computer
The on-board computer is delivered with a
partially charged rechargeable battery. Charge
this battery via the USB port or the system for
at least one hour before it is used for the first
time.
Attach the control panel in such a way that the
buttons are almost vertical to the handlebars.
Set the language when you first put it into
operation.
Assembly
42