Status Page Definitions; Table 6: Status - Grandstream Networks HT818 Administration Manual

•
FXS Ports: Configures SIP accounts settings, Off hook Auto-dial.

Status Page Definitions

Status
MAC Address
WAN IPv4 Address
WAN IPv6 Address
Product Model
Hardware Version
Software version
Software Status
System Up Time
CPU Load
Network Cable Status
Table 6: Status Page Definitions
Shows device ID in hexadecimal format. This is needed by network administrators
for troubleshooting. The MAC address will be used for provisioning and can be
found on the label on original box and on the label located on the bottom panel of
the device.
Note: The device has two MAC addresses, one for the WAN port and one for the
LAN port. The MAC address located on the bottom panel of the device is the MAC
address of LAN port. The MAC address of WAN port is MAC address of LAN port
+1.
Example: MAC Address: WAN - "00:0B:82:25:AF:32", LAN - "00:0B:82:25:AF:31".
Displays assigned IPv4 address.
Displays assigned IPv6 address.
Displays product model info. Default is HT818.
Displays the hardware revision information and the part number.
•
Program: Specifies Program version.
This is the main firmware release number, which is always used for
identifying the software system of the HT818.
•
Bootloader: Specifies Boot version.
•
Core: Specifies Core version.
•
Base: Specifies Base version.
•
CPE: Specifies CPE version. CPE version is displayed only when HT818
is connected to an ACS using TR-069 protocol.
Indicates the current software status of the HT (Running or Stopped).
Indicates actual system time and uptime since last reboot.
Indicates CPU load (%)
Indicates status of the cable (Up/Down) and speed information of the connection
(Full/Half).
Up/Down means cable connected/disconnected.
Full/Half means full duplex/half duplex.
HT818 Administration Guide
Version 1.0.27.2
P a g e | 26