Grandstream Networks HT818 Administration Manual page 29

HTTPS Web Port
Disable SSH
SSH Port
Disable Telnet
Telnet Port
WAN Side Web/SSH
Access
White List for WAN Side If "WAN Side Web/SSH Access" is set to "Yes" or "Auto". Users can configure the
Black List for WAN Side If "WAN Side Web/SSH Access" is set to "Yes" or "Auto". Users can configure the
Internet Protocol
Customizes HTTPS port used to access the HT818 web UI. Default is 443.
Enables/disables the SSH access. Default is No (disabled).
Allows users to self-configure SSH Port number.
By default, the port number is 22.
Enables/disables the Telnet access. Default is Yes.
Allows users to self-configure Telnet Port number.
By default, the port number is 23.
Enables / Disables the Web and SSH access through the WAN port. The available
options are the following:
• No: No access to the web or SSH from any IP address on the WAN side.
• Yes: Access for the Web GUI and SSH is enabled on the WAN side.
• Auto: Only private IP could access the web or SSH on the WAN side.
Default setting is Auto
white List for WAN Side to be used for remote management.
Multiple IPs are supported and need to be separated by "space".
Example: 192.168.5.222 192.168.5.223 192.168.7.0/24
Note: If both blacklist and whitelist are not empty, the blacklist is processed first,
followed by the whitelist.
black List for WAN Side to ban WAN side web access.
Multiple IPs are supported and need to be separated by "space".
Example: 192.168.5.222 192.168.5.223 192.168.7.0/24
Note: If both blacklist and whitelist are not empty, the blacklist is processed first,
followed by the whitelist.
Selects one of the following IP protocol modes:
•
IPv4 Only: Enforce IPv4 protocol only.
•
IPv6 Only: Enforce IPv6 protocol only.
•
Both, Prefer IPv4: Enable both IPv4 and IPv6 and prefer IPv4.
•
Both, prefer IPv6: Enable both IPv4 and IPv6 and prefer IPv6.
Note: Make sure to reboot the phone for the changes to take effect.
HT818 Administration Guide
Version 1.0.27.2
P a g e | 28