Table 7: Ht488 Device Status; Table 8: Ht488 Basic Settings; Efinitions; Definitions - Grandstream Networks HT-488 User Manual

NOTE: If you can not log into the configuration page by using the default password, please check with
the VoIP service provider. It is most likely the VoIP service provider has provisioned the device and
configured for you therefore the password has already been changed.
After a correct password is entered in the login screen, the embedded web server will respond with the
Configuration pages which are explained in details below.
T 7: HT488 D
ABLE EVICE
MAC Address
IP Address
Product Model
Software Version
System Uptime
Registered
PPPoE Link Up
NAT
T 8: HT488 B S
ABLE ASIC
End User Password
Web Port
IP Address
DHCP hostname
DHCP domain
DHCP vendor class ID
Time Zone
Daylight Savings Time
Grandstream Networks, Inc.
S P D
TATUS AGE

EFINITIONS

The device ID, in HEX format. This is very important ID for ISP troubleshooting.
This field shows IP address of the HT-488.
This field contains the product model info, such as HT-488.
Program: This is the main software release. This number is always used for firmware
upgrade. Current release is 1.0.3.64
Bootloader: current version is 1.1.0.1.
HTML: current version 1.0.3.64.
VOC: current version is 1.0.0.13
This shows system up time since last reboot.
Whether the unit is registered to service provider's server.
This shows whether the PPPoE is up if connected to DSL modem
This shows what kind NAT the HT386 is connected to. It is based on STUN protocol. If
the detected NAT is symmetric NAT, STUN will not work and Outbound Proxy needed
to make HT386 functioning correctly.
P D
ETTINGS AGE EFINITIONS
This contains the password for end user to access the Web Configuration Menu. User
can put new password here. This field is case sensitive with maximum of 25 characters
This is the device's internal HTTP server port. Default is 80.
• If DHCP mode is enabled, then all the field values for the Static IP mode are not
used (even though they are still saved in the Flash memory.) The HT386 will acquire
its IP address from DHCP in the network.
• PPPoE settings is usually for DSL/ADSL modem users. The HT will attempt to
establish a PPPoE session if PPPoE account is set.
• If Static IP mode is selected, the IP address, Subnet Mask, Default Router IP
address, DNS Server 1 (mandatory), DNS Server 2 (optional) fields need to be
configured.
This option specifies the name of the client. This field is optional but may be required
by some Internet Service Providers. Default is blank.
This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
This option is used by clients and servers to exchange vendor-specific information.
Default is blank.
This parameter controls how the displayed date/time will be adjusted according to the
specified time zone.
This parameter controls time displayed in daylight savings time. If set to "Yes", then
the displayed time will be 1 hour ahead of normal time.
The "Optional Rule" is configured to automatically adjust the Daylight Savings Time
(DST) based on the rule set in this field. Rule Syntax:
start-time;end-time;saving
•
Both start-time and end-time have the same syntax:
•
HT488 User Manual
Firmware 1.0.3.64
Page 19 of 33
Last Updated: 4/2007