Accessing The Web Ui - Grandstream Networks HT818 Administration Manual

Accessing the Web UI

Via WAN port
-
For the initial setup, the Web access is by default enabled when the device is using private IP and disabled
when using public IP, and you cannot access the Web UI of your HT818 until it's enabled, the following
steps will show you how to enable it via IVR.
1. Power your HT818 using PSU with the right specifications.
2. Connect your analog phone to phone ports (FXS) of your HT818.
3. Press *** (press the star key three times) to access the IVR menu and wait until you hear "Enter
the menu option ".
4. Press 12, the IVR menu will announce that the web access is disabled, press 9 to enable it.
5. Reboot your HT818 to apply the new settings.
Please refer to steps below if your HT818 is connected via WAN port:
1. You may check your HT818 IP address using the IVR on the connected phone.
Please see
Obtain the HT818 IP address via the connected analogue phone
2. Open the web browser on your computer.
3. Enter the HT818's IP address in the address bar of the browser.
4. Enter the administrator's password to access the Web Configuration Menu.
Note: The computer must be connected to the same sub-network as the HT818. This can be easily done
by connecting the computer to the same hub or switch as the HT818.
Via LAN port
-
Please refer to steps below if your HT818 is connected via LAN port:
1. Power your HT818 using PSU with the right specifications.
2. Connect your computer or switch directly to your HT818 LAN port.
3. Open the web browser on your computer.
4. Enter the default LAN IP address (192.168.2.1) in the address bar of the browser.
5. Enter the administrator's password to access the Web Configuration Menu.
6. Make sure to reboot your device after changing your settings to apply the new configuration.
Note: Please make sure that your computer has a valid IP address on the range 192.168.2.x so you can
access the web GUI of your HT818.
HT818 Administration Guide
Version 1.0.27.2
P a g e | 23