Grandstream Networks HT818 Administration Manual page 32
Analog telephone adaptor
Hide thumbs
Also See for HT818:
- Administration manual (59 pages) ,
- User manual (42 pages) ,
- Quick installation manual (21 pages)
Table of Contents
Advertisement
NAT TCP Timeout
NAT UDP Timeout
Uplink Bandwidth
Downlink Bandwidth
Enable UPnP Support
Reply to ICMP on WAN
Port
Cloned WAN MAC
Address
Enable LAN DHCP
LAN DHCP Base IP
Range: 0 – 4096, default is 1024. Typically, one port per connection
NAT TCP idle timeout in seconds. Connection will be closed after preconfigured,
timeout if not refreshed. Range: 0 - 3600
NAT TCP idle timeout in seconds. Connection will be closed after preconfigured,
timeout if not refreshed. Range: 0 – 3600, default is 300
Specifies the maximum uplink bandwidth permitted by the device. This function is
disabled by default. The total bandwidth can be set as: 128K, 256K, 512K, 1M,
2M, 3M, 4M, 5M, 10M or 15M. The primary function of this setting is to limit the
uplink bandwidth for the device internal system, signaling and NATed traffic.
Example: When 512k is configured, there will be at least 512kbps limited for
internal system, signaling and NATed traffic. Voice or RTP stream will never be
limited.
Specifies the maximum downlink bandwidth permitted by the device. This function
is disabled by default. The total bandwidth can be set as: 128K, 256K, 512K, 1M,
2M, 3M, 4M, 5M, 10M or 15M. The primary function of this setting is to limit the
download bandwidth for the device internal system, signaling and NATed traffic.
Example: if 128 is configured, there will be at least 128kbps limited for internal
system, signaling and NATed traffic. Voice or RTP stream will never be limited.
When set to "Yes", the HT818 acts as an UPnP gateway for your UPnP enabled
applications. UPnP = "Universal Plug and Play"
Default is No.
When set to "Yes", the HT818 responds to the PING command from other
computers but is also made vulnerable to DOS attacks.
This allows the user to change/set a specific MAC address on the WAN interface.
Note: Set in Hex format
When set to "Yes", device will function as a simple router and LAN port will provide
IP addresses to internal network. Connect the WAN port to ADSL/Cable modem
or any other equipment that provides access to public Internet
Base IP Address for a LAN port. Default factory setting is 192.168.2.1. Note:
When the device detects WAN IP is conflicting with LAN IP, the LAN base IP
HT818 Administration Guide
Version 1.0.27.2
P a g e
|
31
Advertisement
Table of Contents
