Utility Voltage Monitor Timer (Brown Out) - Generac Power Systems PowerPact 6561 Installation Notes

 The generator will not start or will be shut down if already running.
 The Red light will flash every 5 seconds.
 The internal buzzer will sound once every 5 seconds.
 The buzzer may be silenced by briefly pressing and releasing the test button (after the buzzer has
sounded).
 The buzzer will pulse twice to indicate it has been silenced and will not reactivate until a new alarm is
detected.
6424 Utility Voltage Monitor Timer (Brownout Kit)

Place the generator in the OFF mode, open the circuit breaker on the generator. De-energize the
utility power to the transfer switch.
 Use the relay socket to mark the mounting hole locations, and drill two M3.6 holes. Mount the socket
using two Taptite screws and flat washers.
 Ensure the keyway in the center of the socket is facing the bottom of the enclosure. This causes the
writing on the VM relay to be face up when the installation is complete.
94