Generac Power Systems PowerPact 6561 Installation Notes page 31

Test for Leaks and Pressure

Check the installation for leaks by spraying all connection points with a soap solution made of
dishwashing soap and water. You should not see the solution being blown away of form bubbles. (A
gas installer may have better leak test procedures)

Check the gas pressure at the test port with a Manometer to ensure the pressure is within specified
values. If not contact the local gas supplier.
 Close the Gas Valve

Remove the top gas pressure test port from the regulator and install the gas pressure tester
(Manometer)
 Open the gas supply valve and ensure the pressure in with in the specified values.

Close the gas valve when completed
31