Activation - Generac Power Systems PowerPact 6561 Installation Notes

Installation Wizard
 The maintenance intervals will be initialized when the exercise time is entered.

The Factory set exercise time is Wednesday at 1:00pm. The exercise time can be changed at any time
via the edit menu.
 Note: If the battery is disconnected or the fuse removed, the installation wizard will operate upon
power restoration.
 The only difference is, the display will only ask for the current time and date.
PowerPact
 Control Panel

Note: Damage caused by mis-wiring of the interconnect wires is Not warrant-able.
 Loss of Utility power will cause either the Auto or Off or Manual buttons to flash. Whichever mode the
generator is in at the time of Utility loss.
PowerPact - Activation
 Note: If the Auto button is pressed prior to activation the Auto, Off, and Manual LEDs will flash three
times indicating activation is required.
 When you call or go online for your activation code you will be given a sequence of six (6) button
presses using the Auto, Off, and Set Exercise buttons.
 Begin by holding the Off button for 3 seconds. All the LEDs will flash twice indicating that the
activation mode has begun.
 You have 20 seconds to enter the six key sequence activation code. The Yellow Maintenance button
will flash every time you press a button.
 If you take longer than 20 seconds it will time out and you must begin the activation sequence again.
 If you enter the wrong code the Auto, Off, and Manual buttons will flash 3 time and you have to start
over again.
Activation is complete when all the numbers are entered
and the display shows - Select Hour (0-23)
66